INFINTY COUNTERTOP | Made-to-measure worktops | Acquabella

Bespoke worktops

INFINITY

The INFINITY new collection offers the possibility of creating a fully personalized unit. With a maximum length of 2200mm, it is almost always possible to place the wash basin where desired. Three basin sizes are available of 420, 520 or 620 mm length.
This collection is presented in SLATE, BETON, NUDE, ARDESIA, ZERO and ETHNIC textures. Three options are available: without panels (SF) to install ontop a piece of furniture, with 135 mm panels (CF) and in 40 mm thickness (CFR) to install as a suspended vanity unit.
In CF version it is possible to choose between integrated or metallic towel rails. In CFR option, frontal and lateral metallic towel rails are available.

Features

Minimum format

600 mm

Maximum format

2200 mm

Height

135 mm (CF)
40 mm (CFR)
16 mm (SF)

Depth

460-510 mm

Basins

420x310 mm
520x310 mm
620x310 mm

Downloads INFINITY

FAQs

  • What products may I use to clean the worktops AKRON Acquabella after the installation ?
    To clean any traces of glue and cement mortar use a descaler called Fugasoap (KERAKOLL), DETERTEK from FILA brand, because it is specific for the removal of debris from construction works, also used for the removal of other components such as salt, rust an limescale, please read the instructions. DO NOT RUB, let the product act; NEVER USE PADS (SCOTCH BRITE, or NATURAL FIBER) nor SOLVENTS, ACID, ALKALI OR ABRASIVE. After cleaning, rinse thoroughly and ensure sufficient ventilation of the bathroom. It is not dangerous for the user an not dangerous for the environment. For more information, you can check our Youtube channel Acquabella Bath.
  • What products may I use to clean my Acquabella AKRON worktops daily ?
    Soap and water applied with a non-abrasive sponge. NEVER USE PADS (SCOTCH BRITE, or NATURAL FIBER) nor SOLVENTS, ACID, ALKALI OR ABRASIVE.
  • Is there a solution if the surface of my AKRON Acquabella worktop is damaged ?
    Even we take the utmost care to protect the shower tray during the installation, it is possible that for various reasons the shower tray surface could be damaged. For these cases we have a REPAIR KIT with the same colour and easy application.
  • How to drill the tap hole?
    When placing the order, indicate in a sketch where to locate the tap holes. If it has been ordered without a hole, it can be done on side, protecting the worktop well so as not to damage it by using a drill and a 35 mm diameter metal crown.
preguntas frecuentes

Contact

Message

terms and conditions.

Secured By miniOrange