ONE COUNTERTOP | Made-to-measure worktops | Acquabella

Bespoke worktops

ONE

One collection offers 2 kinds of product: as a worktop for sink On-Top or as a shelf. There is a SF (no front and side panels) version, CFR with panels of 40 mm and CF with panels of 135 mm. Minimum length is 700 mm and maximum is 2200 mm.

Features

Minimum format

700 mm

Maximum format

2200 mm

Height

120 mm (CF)
40 mm (CFR)
16 mm (SF)

Depth

460-510 mm

Naturally made colors

Naturally made colors

Naturally made colors

Naturally made colors

Naturally made colors

Naturally made colors

Naturally made colors

RAL/NCS Colors

Finishes

* The colours shown in the images on the website are approximate. The appearance of the material may vary slightly from that shown in the photographs.

Downloads ONE

FAQs

  • What products may I use to clean the worktops AKRON Acquabella after the installation ?
    To clean any traces of glue and cement mortar use a descaler called Fugasoap (KERAKOLL), DETERTEK from FILA brand, because it is specific for the removal of debris from construction works, also used for the removal of other components such as salt, rust an limescale, please read the instructions. DO NOT RUB, let the product act; NEVER USE PADS (SCOTCH BRITE, or NATURAL FIBER) nor SOLVENTS, ACID, ALKALI OR ABRASIVE. After cleaning, rinse thoroughly and ensure sufficient ventilation of the bathroom. It is not dangerous for the user an not dangerous for the environment. For more information, you can check our Youtube channel Acquabella Bath.
  • What products may I use to clean my Acquabella AKRON worktops daily ?
    Soap and water applied with a non-abrasive sponge. NEVER USE PADS (SCOTCH BRITE, or NATURAL FIBER) nor SOLVENTS, ACID, ALKALI OR ABRASIVE.
  • Is there a solution if the surface of my AKRON Acquabella worktop is damaged ?
    Even we take the utmost care to protect the shower tray during the installation, it is possible that for various reasons the shower tray surface could be damaged. For these cases we have a REPAIR KIT with the same colour and easy application.
  • How to drill the tap hole?
    When placing the order, indicate in a sketch where to locate the tap holes. If it has been ordered without a hole, it can be done on side, protecting the worktop well so as not to damage it by using a drill and a 35 mm diameter metal crown.
preguntas frecuentes

Contact

    Message

    terms and conditions.